10 Inspirational Graphics About Fiat 500 Replacement Key Cost

fiat punto spare key cut 500 Replacement key code fiat Fob

If your remote key fob isn't working, it's time to replace the battery. If you replace the battery, but it still doesn't work, the problem may be elsewhere.

At United Locksmith, we specialize in the creation of new keys for classic cars. We have all the tools and components needed to perform this service.

Dead Coin Battery

A dead battery is the primary reason for your Fiat 500 keyfob not locking or unlocking the doors. The key fob contains an in-built battery that can quickly deplete in the event that it is not frequented enough. If your remote started to show signs of weakness such as a loss of range, and then stopped working completely, the battery is probably dead.

The battery in the key fob is held in place by metal clips that retain it. If the clips aren't tightly secured, they could result in contact issues that prevent your remote to receive power. Make use of a flathead screwdriver to break open the retaining clip and then remove the old battery. Make sure to use a battery with the same size, voltage and specification as the original.

The key fob could be damaged or corroded by water exposure. Even a brief bath in soapy water may cause damage to the electronic chip inside. Make sure your key fob is dry.

Water Damage

If your key fob isn't functioning correctly, it could be due to water damage. Key fobs have rubber seals to protect them from being damaged by light rain or splashes of water, but it is vital to keep your keys out of the pool, ocean, and washing machine!

The key fob contains an electronic chip that transmits a signal to your car's immobilizer system. This is what allows your 500 to start or lock, but if the chip gets saturated, it won't be able to longer work.

You can clean the inside electronics of your keyfob with isopropyl Alcohol or an electronic cleaner to see whether they're still in good condition. It is recommended to replace the key fob if it's submerged in salt water instead of trying to fix it yourself.

While a replacement fob could cost you a bit of money, it is a lot cheaper than paying for your fiat 500 car key Replacement 500 to be towed to the dealership and repaired! You could also do it yourself by following just a few steps. Just ensure you have the correct type of battery before you attempt to open your key fob. You can find step-by-step instructions for any key fob in your car online.

Faulty Chip

The chip in the key fob communicates with the car's immobiliser system to ensure the vehicle is only capable of starting when the correct key is used. If the chip is damaged or destroyed the car won't start no matter what you do.

A damaged chip could occur due to a variety of reasons, but most often it is due to water damage or the battery being dead. It is recommended to leave the repair to a professional locksmith, who can replace the chip in a short time and at a reasonable cost.

If your key fob fails to function after exposure to clean water from the tap or rain, take off the battery and wipe down the electronic component with a towel to ensure it is fully dry before putting it back into. If the key fob will not function, there's a chance that it has damaged components and requires to be replaced.

Many people will seek out their dealer when in need of a new fiat punto replacement key key fob, but it can be a expensive alternative. United Locksmith is the best place to go if you need your Fiat keyfob fixed at a reasonable cost. We have the tools and experience necessary to fix your fiat key replacement key fob in a quick and professional way.

Faulty Receiver Module

Fiat key fobs transmit an electronic signal to the vehicle, which will unlock and lock doors (and start the car for those with an automatic transmission) up to 50 feet. However there are a few things that can cause the fob to cease working. This includes a dead coin battery or water damage buttons, worn ones, a receiver module issue and signal interference, or an electronic chip malfunctioning.

If the fob is in the pocket of someone who has suffered severe trauma (such as being dropped onto the hard floor or washed in a washing machine), it may not be able to communicate with the Body Control Module (BCM) of the car. This is because the BCM is secured and will only accept a signal from a genuine original key and not accept any other.

You'll have to replace the fob if this happens. A professional locksmith can handle every aspect of the key replacement procedure, including programming a new one for the 500. In fact, they could provide you with a duplicate key that functions exactly like the original fob (and costs less than the price).